Analysis of Multi-Body Separation Characteristics of Trans-Medium Vehicles

WANG Shuai; DONG Meng; WANG Sheng

doi:10.11993/j.issn.2096-3920.2023-0022

Volume 32 Issue 1

Feb 2024

Turn off MathJax

Article Contents

Article Navigation > Journal of Unmanned Undersea Systems > 2024 > 32(1): 152-157

WANG Shuai, DONG Meng, WANG Sheng. Analysis of Multi-Body Separation Characteristics of Trans-Medium Vehicles[J]. Journal of Unmanned Undersea Systems, 2024, 32(1): 152-157. doi: 10.11993/j.issn.2096-3920.2023-0022

Citation:

WANG Shuai, DONG Meng, WANG Sheng. Analysis of Multi-Body Separation Characteristics of Trans-Medium Vehicles[J]. Journal of Unmanned Undersea Systems, 2024, 32(1): 152-157. doi: 10.11993/j.issn.2096-3920.2023-0022

Citation:

PDF( 1745 KB)

Analysis of Multi-Body Separation Characteristics of Trans-Medium Vehicles

doi: 10.11993/j.issn.2096-3920.2023-0022

1.
The 705 Research Institute, China State Shipbuilding Corporation Limited, Xi’an 710077, China
2.
First Military Representative Office of Navy Equipment Department Stationed in Xi’an, Xi’an 710077, China

Received Date: 2023-03-07
Accepted Date: 2023-05-08
Rev Recd Date: 2023-04-19

Available Online: 2024-01-29

Abstract

Abstract

This paper studied the underwater separation characteristics of pods of trans-medium vehicles by numerical simulations of computational fluid dynamics and dynamics model simulations and analyzed the hydrodynamic forces exerted on the pods before and after separation. The analysis results show that 1) with appropriate shapes, the pods can separate from the vehicle under the action of hydrodynamic forces; 2) the opening angle and opening angular velocity of the pods have a large impact on the hydrodynamic forces. At different opening angles, the generation mechanisms of the separation moment are different. At a small opening angle, the opening of the pods mainly relies on the internal and external pressure difference generated by the low pressure in the outer separation zone, and the fluid moment is mainly generated by the front section of the pods. At a large opening angle, the opening of the pods mainly relies on the normal force caused by water flow impact, and the moment is mainly generated by the middle and rear sections of the pods; 3) the damping moment of the fluid is large when the opening angle of the pods is small, which makes it hard for the pods to separate from the vehicle quickly at the initial stage. As the opening angle increases, the damping moment of the fluid gradually decreases, and the opening angular velocity of the pods rapidly increases. Therefore, appropriate shapes and separation methods should be designed to reduce the initial damping moment of the fluid of the pods during underwater separation.
- trans-medium vehicle,
- underwater separation,
- multi-body separation,
- pod

FullText(HTML)

References(10)

References

[1]	徐新栋, 李建辰, 曹小娟. 鱼雷缓冲头帽入水冲击性能研究[J]. 鱼雷技术, 2012, 20(3): 161-165. Xu Xindong, Li Jianchen, Cao Xiaojuan. Water-entry impact performance of torpedo’s cushion nose cap[J]. Torpedo Technology, 2012, 20(3): 161-165.
[2]	严忠汉. 试论鱼雷入水问题[J]. 中国造船, 2002, 43(3): 88-93. doi: 10.3969/j.issn.1000-4882.2002.03.013 Yan Zhonghan. A brief review of water-entry problems for torpedo[J]. Shipbuilding of China, 2002, 43(3): 88-93. doi: 10.3969/j.issn.1000-4882.2002.03.013
[3]	权晓波, 包健, 孙龙泉, 等. 基于耦合欧拉-拉格朗日算法的航行体缓冲头帽冲击性能[J]. 兵工学报, 2022, 43(4): 851-860. doi: 10.12382/bgxb.2021.0168 Quan Xiaobo, Bao Jian, Sun Longquan, et al. Impact performance of cushion nose cap of underwater vehicle based on CEL method[J]. Acta Armamentarii, 2022, 43(4): 851-860. doi: 10.12382/bgxb.2021.0168
[4]	李鸿, 李光磊, 刘志远, 等. 基于流固耦合的降载空化器高速入水数值研究[J]. 振动与冲击, 2021, 40(23): 254-259. Li Hong, Li Guanglei, Liu Zhiyuan, et al. Numerical simulation of high-speed water entry of cavitator with load reduction device based on fluid-structure interaction[J]. Journal of Vibration and Shock, 2021, 40(23): 254-259.
[5]	潘瑛, 徐德民, 宋保维, 等. AUV水下分离运动及分离方式研究[J]. 西北工业大学学报, 2004, 22(4): 505-508. Pan Ying, Xu Demin, Song Baowei, et al. On the kinematics and mode selection for separation motion of AUV[J]. Journal of Northwestern Polytechnical University, 2004, 22(4): 505-508.
[6]	曹廷旭, 宋保维, 潘光. 水下航行器载荷分离模型的建立与仿真[J]. 鱼雷技术, 2004, 12(3): 17-19. Cao Tingxu, Song Baowei, Pan Guang. Dynamics model and simulation for an AUV load separating[J]. Torpedo Technology, 2004, 12(3): 17-19.
[7]	何振民, 刘广涛, 王宝寿, 等. 水下高速航行体分离特性数值研究[C]//第十一届全国流体力学学术会议论文摘要集. 深圳: 中国力学学会, 2020.
[8]	宋保维, 邵成, 李家旺, 等. 自主式水下航行器载荷水下浮力解脱分离方法[J]. 兵工学报, 2007, 28(2): 249-252. doi: 10.3321/j.issn:1000-1093.2007.02.028 Song Baowei, Shao Cheng, Li Jiawang, et al. A new method of load separation from autonomous underwawer vehicle[J]. Acta Armamentarii, 2007, 28(2): 249-252. doi: 10.3321/j.issn:1000-1093.2007.02.028
[9]	宋金梁, 申洪彬, 刘继鑫, 等. 多级可分离式AUV系统设计与仿真分析[J]. 海洋工程, 2019, 37(5): 107-116. Song Jinliang, Shen Hongbin, Liu Jixin, el al. Design and CFD simulation analysis of a multistage separable AUV[J]. The Ocean Engineering, 2019, 37(5): 107-116.
[10]	白治宁, 王明洲, 王旅, 等. 雷箭分离时运载器-分离舱组合体运动特性非定常数值仿真[J]. 水下无人系统学报, 2018, 26(2): 122-128. Bai Zhining, Wang Mingzhou, Wang Lü, et al. Unsteady numerical simulation on motion characteristics of combination of rocket and separating-capsules during torpedo-rocket separation[J]. Journal of Unmanned Undersea Systems, 2018, 26(2): 122-128.